Jump to Navigation
Clifford 650 Error Codes
When returning to your car if the alarm chirps 3 times, this indicates the alarm was triggered while you were away from the vehicle.
The status LED will then flash a number of times, repeating the sequence 3 times. (e.g. Door Switch = 4 Flashes, Pause, 4 Flashes, Pause, 4 Flashes)
Please note: this sequence is not automatically repeated.
The specific zone that triggered the alarm to go off, can be seen from this look-up table:
Clifford 650 Error Codes |
|
| 1 LED Flash | Proximity Sensor |
| 2 LED Flashes | Omnisensor |
| 3 LED Flashes | Tilt/Motion Sensor |
| 4 LED Flashes | Door Switch |
| 5 LED Flashes | Boot Switch |
| 6 LED Flashes | Bonnet Switch |
| 7 LED Flashes | Optional Sensors |
| 8 LED Flashes | Glass Tamper Sensor or Ultrasonic Sensor |
| 9 LED Flashes | BlackJax Activation |
| 10 LED Flashes | Alarm Power Reset |
| 1 low-pitched chirp | Remote Control Battery Low |
Please note: Some of these sensors and features are optional at the time of alarm installation.
Return to Clifford Concept 650 Alarm system.
Last updated - January 2025