Thatcham Recognised Installer Logo
CONTACT US

Clifford Concept 650 Remote Sensor Adjustment

The Clifford Concept 650 remote sensor adjustment is achieved by a combination of button presses on the hand-held remote control.

Pressing the Clifford G5 button three times followed by the Star button allows access to the primary zone and here the Proximity sensor can be increase or decreased. Subsequently pressing the Double Star button allows the seconday zone to be accessed and here the Warn-Away sensor can be adjusted. To only access the Clifford 650 Warn-Away sensor, press G5 three times, the Star button once, followed by the Double Star button.

The Lock / Unlock button is used to take the sytem out of these zones and return to normal operation. Once for Proximity sensor and twice if in Warn-Away seconday zone.

 

Clifford Concept 650 Remote Sensor Adjustment

1
Disarm the car alarm system. Clifford 650 MK2 remote sensor changes
2
    Press Cliford G5 iconthree times followed by the Engine remote startbutton to adjust the internal Proximity sensor.
  1. LED will turn on and siren will chirp once.
  2. Primary zone now entered, press Boot release to increase sensitivity or Engine remote startto decrease.
3
    Press to adjust the Warn-Away sensor.
  1. Siren will chirp once.
  2. Secondary zone now entered, press Boot release to increase sensitivity or Engine remote startto decrease.
4
    Press to return from secondary zone and lock in warn-away changes.
  1. Siren chirps two times.
  2. Are now back in primary zone.
  3. Press to exit programming mode altogether and lock in proximity sensor changes.
  4. Siren will chirp three times.

Please note that when adjusting sensitivity up and down this can be done in single steps (one press at a time) or push and hold to adjust rapidly.

Printable version of Clifford remote sensor adjustment.

 

Return to Clifford Concept 650 information page.

 

Page last updated May 2019